BIXOLON SRP-770 Instrukcja Operatora Pobierz pdf (Strona 5)

Installing or Replacing the Paper Roll

① Open Cover ② Open Guides

③ Install Roll

⑤ Close Cover

④ Close Guides to the Width of the paper

6. Setting The Dip Switches

6-1. Setting the Dip Switches

The Dip Switches are located on the bottom of the printer. The Dip Switches are used to

set the Printer to perform various functions. Follow these steps when changing Dip

Switches setting :

1. Turn the printer power switch off.

2. Remove the screw on the bottom of the printer and open the bracket.

3. Flip the Dip Switches using tweezers or another narrow-ended tool. Switches are

off when up and on when down in the Figure below.

4. The new setting takes effect when you turn on the printer.

Note : Always change Dip Switch settings only when the printer is turned off.

6-2. Functions of Dip Switches

6-2-1. Dip S/W 1 6-2-2. Dip S/W 2

NO Functions

Details

2 1 Speed

Off Off 2.5 ips

Off On 3.0 ips

On Off 4.0 ips

1,2

Speed

Selection

On On 5.0 ips

4 3 Density

Off Off 0(Low)

Off On 7

On Off 13

3,4

Density

Selection

On On 20(High)

5,6,

Developer

Mode

Default --- off

Off Move to Cutting Position

Position

Selection

On Move to top of next page

No Functions Details

2 1 Baud Rate

Off Off 9,600 bps

Off On 19,200 bps

On Off 57,600 bps

1,2

Baud

Rate

On On 115,200 bps

Off Xon/Xoff

Flow

Control

On RTS/CTS

Off Serial & Parallel

Interface

Selection

On Serial & USB

5~8

Developer

Mode

Default --- off

1 2 3 4 5 6 7

Komentarze do niniejszej Instrukcji

Brak uwag

BIXOLON SRP-770 Instrukcja Operatora Strona 5

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Drukarki etykiet BIXOLON SRP-770